BP begins to remove drilling pipe

BP PLC  said
Saturday that it has begun an attempt to remove the drilling pipe from the
ruptured well that unleashed the Deepwater Horizon spill.

The attempt, which began Saturday morning, follows the
successful completion of a 48-hour ambient pressure test, in which the company
determined that if the sealing cap and the blowout preventer that sit atop of
the well are removed, no oil or gas will come out. BP aims to remove 3,500 feet
of drilling pipe before it can proceed to remove the blowout preventer and
replace it with a new one.

The head of the federal oil spill response effort,
retired U.S. Coast Guard Admiral Thad Allen, ordered BP to produce a plan to
fish out the blowout preventer. In a letter released Saturday, Allen said that
BP must by Sunday let the U.S. government know how it can remove the sealing
cap and blowout preventer while keeping them sufficiently intact for
investigators trying to assess the cause of the explosion that killed 11 and
unleashed the worst offshore oil spill ever. U.S. officials “will take
custody” of all equipment, Adm. Allen said.

The replacement of the blowout preventer is necessary,
U.S. officials said, because there are concerns that the operation that is
designed to permanently kill the well could endanger a cement plug that has
capped the well since early August. The operation, known as the “bottom
kill,” would inject mud and drilling cement in the area between the
drilling pipe and the surrounding rock formation, known as the annulus. If
pressure in the annulus increases rapidly, it could make oil trapped within
blow through the cement plug at the top of the well.

Once BP places the new blowout preventer atop the well,
the company will proceed to drill a relief well that will intersect the damaged
well near its bottom. From there, it will inject the mud and cement, marking
the official end of the Deepwater Horizon spill. However, clean-up operations
around the Gulf Coast, as well as environmental controversy about the ultimate
effects of the release of about 4 million barrels of crude into the ocean, are
likely to last for months.

The oil flow has been shut in since mid-July, when BP
installed the sealing cap atop of the well. In early August, it pushed the oil
back into the reservoir by injecting mud and cement from the top.

Comments are closed.